LinkBack URL
About LinkBacks
I'm using OCZ DDR3 PC3-16000 Platinum Enhanced Bandwidth Edition which I just got , to help me through Cellshock Woes I'll see which is bestCPu is an E8200.
I started out on a familiar path :-
8x480(3,840) @ 1:2 1,1,920
Click to Enlarge
]
Minimal bios tweaking , used 060BTA :-
Went a bit further managed :-Code:CPU Feature Thermal Management Control:.......... Enabled PPM(EIST) Mode:........................... Disabled Limit CPUID MaxVal:.........................Disabled CIE Function: ................................Disabled Execute Disable Bit:........................ Disabled Virtualization Technology:................ Disabled Core Multi-Processing:.................... Enabled Exist Setup Shutdown:................... Mode 2 Shutdown after AC Loss:................ Disabled O.C. Fail Retry Counter:..................0 CPU Clock Ratio.............................:8 CPU N/2 Ratioo.............................: Disabled Target CPU Clock..........................: 3,840 CPU Clock....................................: 480 Boot Up Clock...............................: Auto CPU Clock Amplitude......................: 700mV CPU Clock0 Skew........................... 0ps: CPU Clock0 Skew........................... 0ps DRAM Speed.................................: 400/1600 Target DRAM Speed........................: 1,920 PCIE Clock....................................: 100mhz PCIE Slot Config.............................: 1X 1X CPU Spread Spectrum......................: Disabled PCIE Spread Spectrum:.................... Disabled SATA Spread Spectrum....................: Disabled Voltage Settings CPU VID Control..............................: 1.38125v CPU VID Special Add Limit.................: Enabled CPU VID Special .............................: Auto DRAM Voltage Control......................: 1.803v SB Core/CPU PLL Voltage..................: 1.510v NB Core Voltage..............................: 1.467v CPU VTT Voltage.............................: 1.220v Vcore Droop Control.........................: Enabled Clockgen Voltage Contro...................l: 3.45v GTL+ Buffers Strength......................: Strong Host Slew Rate...............................: Weak GTL REF Voltage Control...................: Disable x CPU GTL1/3 REF Volt......................: 113 x CPU GTL 0/2 REF Volt.....................: 100 x North Bridge GTL REF Volt................: 110
8x489(3,912) @ 1:2 1,1,956
Click to Enlarge
]
But that's not OCCT stable.
Tried a few tweaks but nothing really helped , only adjustments to earlier were :-
CPU VID Control = 1.38125-->1.3785v
CPU VTT Voltage. = 1.220 --> 1.255
May be my ignorance of the options at this stage, so any suggestions gratefully recieved
Have tried all bios now, again it might be my newbness, but can't get >500. Looks like it might be back to the Gigabyte GA X48T DQ6 until we get a fresh bios, which is a real shame.
]
]
Reply With Quote
Originally Posted by supershanks
maybe you do have a faulty one?
